Such growth process leads to the formation of InSb NWs with larger diameter
(core-shell structure), which is confirmed by the larger diameter of InSb wires (approximately 200 nm) observed here in contrast to the small diameter (approximately 70 nm) of InAs NWs shown in Additional file 2: Figure S2a (grown under the same growth condition as the InAs seed layers). The faster axial growth in InSb NWs is well supported by the absence of arsenic signal in the EDS spectra of body part of InSb NWs and the presence of arsenic signal in the EDS spectra of the bottom part of InSb NWs. Figure 2 TEM image and the EDS spectra of an InSb NW. (a) TEM image of an InSb NW terminating with an indium droplet. The ‘1’, ‘2’, and ‘3’ circles indicate the regions where the EDS spectra shown in (b) are presented, respectively. (c) TEM image of a NW without a droplet on its end. The arrow indicates the region where the GDC-0973 cell line EDS spectra shown in (d) are acquired. A similar analysis is performed on the other group of NWs without droplet-like ends, where the TEM
image and the related EDS spectra are shown in Figure 2c. Note the EDS spectra are obtained in the area indicated by the arrow in Figure 2c. The EDS spectra measured on the free end of InSb NW shows the same stoichiometry as the NW body with InSb. Similarly, arsenic signal is also observed selleck chemical at the bottom of InSb NW (composition spectra not shown here). This indicates MG-132 datasheet that except the indium droplet end, the second group of NWs shows a similar chemical composition distribution to the first
group of NWs. The absence of In droplets on the NW top end might be related to the catalyst self-consumption during the growth, which has been observed in other catalyst-assisted NWs [13]. Such catalyst self-consumption during the NW growth will lead to a smaller axial growth rate for the NWs [12, 14], which is confirmed by the relatively small length of the second group of NWs. All the second group of InSb NWs (without In droplet on the top end) present a length less than 1 μm, while the first group of InSb NWs (with indium droplet on the top end) are all longer than 2 μm. It should be noted that that catalyst self-consumption during the NW growth will lead to the formation of randomly located NWs with wide distributed lengths, which, however, does not agree with the morphology observed for the second group of InSb NWs. As shown in Figure 1, the second group of NWs has a narrow length size distribution and is homogeneously located in well-defined parts of the substrate surface, which does not accord with the catalyst consumption dependence on the catalyst dimension. This suggests that the growth process of the second group of InSb NWs is more complicated compared with that of the first group InSb NWs, and some other factors except VLS model might take effect.