Agah et al.[13] designed a high-speed LGX818 chemical structure signal open-tube GC column, through which components of the mixture were separated

within 10 s. However, the separation efficiency and sample capacity of the fabricated column can be improved further. In 1975, Golay introduced the principle of multi-capillary columns (MCCs). MCCs demonstrated much higher sample capacities when compared with single capillary column [14, 15]. MEMS-based multi-capillary GC columns were subsequently designed. The sample capacity of MCC was ten times higher than in the single channel [16]. However, for MCCs with a short length, the separation efficiency needs to be improved further. Our work focuses on improving separation efficiency by designing a column with a high aspect ratio. In this study, MEMS techniques were applied in the fabrication of an MCC. Using the DRIE process, a 50-cm-long, 450-μm-deep,

and 60-μm-wide four-capillary column was fabricated. The static coating method was used for coating the column with the stationary phase – dimethyl (94%) + vinyl (1%) + phenyl (5%) polysiloxanes (SE-54). Mixtures of DMMP, TEP, and methyl salicylate (representing CWAs) were used as Selleck HSP inhibitor Samples to evaluate the efficiency of the column. Dichloromethane, ethanol, and toluene were added as interference components to the analytes to produce new sample mixtures. Methods Materials and reagents A solution of SE-54 (5% phenyl, 1% vinyl, 94% dimethyl polysiloxane) was purchased from Sigma-Aldrich (St.

Louis, MO, USA) for use as the stationary phase. The internal unions were purchased from VICI (Valco Instruments Cyclin-dependent kinase 3 Co., Schenkon, Switzerland), and the fused Tucidinostat in vivo silica tubing was purchased from SGE (SGE Analytical Science, Ringwood, VT, Australia). All analytes were purchased from J&K Scientific Ltd. (Beijing, China). Samples (mixture of gases) were generated by a MF-3C dynamic vapour generator, where the analyte-solvent mixtures were injected into a vaporising chamber. Two digital mass flow controllers in the vapour generator regulated the concentration of the sample. MEMS fabrication The DRIE technique was applied to create an MCC with 7.5:1 aspect ratio (length = 50 cm, depth = 450 μm, and width = 60 μm). The steps involved in MCC fabrication is shown in Figure 1. The aluminium film was deposited on type <100 > silicon wafer by electronbeam evaporation. The thickness of the aluminium film was approximately 3 μm. The photoresist was then coated on the wafer (4-μm-thick layer) and patterned as an etch mask for aluminium. The etchant was used to wash the parts of unprotected aluminium film, thereby exposing the silicon surface underneath. The DRIE etching process was then performed by introducing the two gases (sulphur hexafluoride, SF6, and octafluorocyclobutane, C4F8) alternately into the chamber. SF6etched the silicon while C4F8 formed a passive layer [17]. The channels formed vertical sidewalls via this technique. Figure 2a shows the MCC structure.