For applying graphene as a transparent conducting and surface field layer on Si solar cells, we chose SiO2 as the

CCI-779 purchase antireflection layer. Experimental and simulation studies were performed on the planar Si solar cell to investigate the reflectance properties of monolayer graphene on Si surface. Subsequently, the thickness of SiO2 layer as an antireflection coating for G/Si solar Tariquidar research buy cell was optimized. It was observed that a 100-nm-thick SiO2 layer was sufficient to work as an antireflection layer over the graphene-Si interface. SiO2 (refractive index 1.45) was chosen due to its well-known antireflection properties [31]. Figure 2 Optical image and transmittance of graphene. (a) Optical image of a large-area (~6.5 × 2.5 cm2) graphene transferred onto a SiO2 (300 nm)/Si substrate. (b) Transmittance of graphene after it was transferred onto a quartz substrate. The inset photograph of (b) shows the transparency of the transferred graphene sample. Table 1 A comparison find more of transmittance and sheet resistance values of graphene layers used in reported studies on Si solar cells   Method of preparation Transmittance (%) Sheet resistance (Ω/□) Efficiency (%) 1 CVD using Cu foil 96 to 98 900 8.9 [24]

2 CVD using Cu foil 95 to 97 >1000 8.6 [23] 3 CVD using Ni foil 54 to 70 – 1.7 [21] 4 Fame synthesis using Ni foil >75 – 4.3 [32] 5 CVD using Ni foil – 200 2.8 [33] 6 CVD using Cu foil 97 350 8.94 (in the present study) Graphene and SiO2/G overlayers with 100 nm SiO2 thickness were then applied onto the fabricated crystalline Si solar cell having a planar and untextured Si surface (Figure 3a) to experimentally determine the effect of these layers on the performance of solar cell. Figure 3b depicts the dark

and illuminated J-V characteristics of (i) a bare Si solar cell having a planar surface, (ii) graphene on the planar Si solar cell (G/Si), and (iii) 100-nm-thick SiO2 coating on graphene/Si solar cell (SiO2/G/Si). The solar cell performance parameters of open circuit voltage (V OC), short circuit current density (J SC), maximum voltage (V M), maximum current (I M), series resistance (R S), shunt resistance Hydroxychloroquine nmr (R SH), fill factor (FF), and the energy conversion efficiency (Eff.) are shown in Table 2. Data given in Table 2 shows an overall improvement in the performance of the planar Si solar cell with an increase in V OC by 20 mV and in J SC by 10.5 mA/cm2. It is important to note that the graphene overlayer on planar Si solar cell (G/Si) has higher conversion efficiency (7.85%) in comparison to the bare Si cell (5.38%) without graphene layer. This conversion efficiency is further increased to 8.94% on introduction of the antireflection SiO2 layer.