The inset of (a) shows a SEM micrograph of the electrodes fabricated by FIB on the bismuth microwire. Magnetic field dependence of the Hall resistance evaluated from the measured resistance (b) in the range from 0 to 1 T and (c) in the low magnetic field range from 0 to 85 mT with the expected values for bulk bismuth in two directions. (d-f) Magnetic field dependence of the Hall resistance at 250, 200, and 150 K. Figure 7a shows the temperature dependence of the Hall coefficient for

the 4-μm-diameter bismuth microwire calculated from the magnetic field dependence of the Hall resistance using a least-squares method and that for bulk bismuth in two directions. The Hall coefficient (R H) was calculated from [33], where R Hall, d, and B are the Hall resistance, the wire Angiogenesis inhibitor diameter, and the magnitude of the magnetic field, respectively. The measurement was successfully performed from 150 to 300 K, and the result was in the same range as that

for bulk bismuth. However, Hall measurement became difficult in the low temperature range due to a very low signal-to-noise (S/N) ratio of the Hall voltage caused by the high contact resistance of the carbon electrodes fabricated by FIB. This result implies that carbon electrodes are not appropriate for this measurement due to their high resistance. Therefore, we are planning to fabricate electrodes that consist only of tungsten, as shown in the inset of Figure 7a; this will be achieved using another FIB apparatus

that is equipped https://www.selleckchem.com/products/chir-98014.html with an EB for tungsten deposition. Figure 7b shows the temperature Osimertinib cost dependence of the electron (μe) and hole (μh) mobilities estimated from the Hall coefficient and the electrical resistivity according to the following equations that apply the charge-neutrality condition [38]: (1) and (2) where r H, e, ρ, and n are the Hall factor, the elementary charge, the electrical resistivity, and the carrier density, respectively. The resistivity measured for another 4-μm-diameter microwire was utilized for ρ, and the carrier density of bulk bismuth from [2] was utilized in Equation 2. The value of r H was 1.18, because the scattering process of bismuth is assumed to be acoustic phonon scattering [38]. Literature values of the carrier mobilities for bulk bismuth [40, 41] and those expected for the 4-μm microwire and 500-nm nanowire calculated using the mean free path limitation model [23] and assuming the bisectrix direction are also represented in Figure 7. Unfortunately, the crystal orientation of the bismuth microwire was not measured because the sample was fabricated as a trial. It could be confirmed that both the experimental and calculated results for the 4-μm-diameter bismuth microwire and those for bulk bismuth were in the same range at over 150 K, which indicates that the carrier mobilities of the bismuth microwires were successfully evaluated by the Hall measurement.